That should give some perspective of the difference and the removing of the hotspotting too. I'll take one with the plain white gator foam on one side and the painted side on the other. However, I'll try to take some screen snaps this weekend and post sometime Monday. I'll be away on business the next 3 days. HDTV: Projected via component video cables from a Verizon FiOS Digital HDTV settop box Speakers: Cambridge Soundworks MovieWorks 108 Speaker System Receiver: Panasonic SA-XR25 5.1 (via SPDIF) Two 120GB SATA Drives (internal - setup in a Raid 0 Array) Projector: Panasonic PT-L500U LCD (via 7.5m DVI cable) Screen: 80"x45" Behr Silverscreen painted over GatorFoam (Ser # 0001) (3) Not fully satisfied, but sticking with it while I look for something better Projector Results using Pure Behr SS paint, on varying surfaces Paint mixing attachment for a hand power drill It's like brewing a good lager beer, let it mellow a while, then decide.
If you do it while it's still wet, you may see hot-spotting. NOTE: Wait for it to cure enough (about 2 weeks) before judging it. GatorFoam Board (a foam core artist material used for poster mounting)īehr "Silver Screen" (770E-2) mix using Ultra Pure White (UPW) flat latexĢ0/48ths of Raw Umber (a dark, murky yellow/orange-based pigment) If you are looking for a quick down-and-dirty screen for your LCD projector, this took approx 3 hours total, most of that time was waiting for the coats to dry. In my opinion, this gives definite contrast enhancement and deeper blacks than plain blackout cloth or the white GatorFoam surface. So, I rolled two coats on a piece of white GatorFoam, and voila, a cheap two coat solution. Light grey, seemed similar to the "Misty Evening". On a lark, I was leafing through the Behr swatches at my local Home Depot, and found the "Silver Screen" paint.
0 kommentar(er)
